optiquest monitor volume troubleshooting

Verify the HDD is detected or is in good condition.Ģ) If the HDD is not detected or the status is “Abnormal”, please replace the dedicated HDD according to the requirement.Ĥ. Note: Please refer to the “Quick Operation Guide” for the HDD installation steps.Ģ) If you do not want to install a HDD, select “Menu>Configuration > Exceptions”, and uncheck the Audible Warning checkbox of “HDD Error”.Ģ) If the status of the HDD is “Uninitialized”, please check the checkbox of corresponding HDD and click the “Init” button.ģ. Verify at least one HDD is installed in the device.ġ) If not, please install the compatible HDD. Possible Reasons:ī) The installed HDD has not been initialized.Ĭ) The installed HDD is not compatible with the device or is broken-down. There is an audible warning sound “Di-Di-Di-Didi” after a new bought device starts up. If not, please contact tech support for the next steps. Check to see if the problem is resolved by step 1 through step 3. And if not, please modify the input mode of monitor.Ĥ. if the output mode of DVR is HDMI output, then the input mode of monitor must be the HDMI input). Please check the input mode of the monitor matches with the output mode of the device (e.g. Verify Input mode of the monitor is correct. Verify the connection cable is good.If there is still no image display on the monitor after rebooting, please check if t he connection cable is good, and change a cable to connect again.ģ. Verify the device is connected with the monitor via HDMI or VGA cable.If not, please connect the device with the monitor and reboot.Ģ. Possible Reasons:Ĭ) Input mode of the monitor is incorrect. Troubleshooting No image is displayed on the monitor after the device starts up normally.

Optiquest monitor volume troubleshooting